For the option: | Do the following: |
|---|---|
Request Tables | Specify whether or not Adams View prints time-response-request tables in the Tabular output file. ■If you set to On, Adams View writes tables for each request in your model. ■If you set to Off, Adams View does not write the tables. If your simulation has many output steps or you have many requests, specifying Off results in a much smaller tabular output file and conserves disk space. |
Separator | Specify whether or not Adams writes separators to the request, graphics, results, and tabular output files when you modify the model topology in the middle of a Simulation. When running a Scripted simulation, you can change the model topology by adding Adams commands to your script file to activate an element, deactivate an element, change a marker position, or change the type or point of application of a force or constraint. ■If you set to On (which is the default), Adams Solver reads the analysis information into Adams View, one analysis for each block of output between the separators. ■If you set to Off, Adams Solver reads the analysis information into Adams View as a single simulation. This allow you to plot or animate the simulation from beginning to end. |
Yaw Pitch Roll | Set to Yes to specify that rotational values are to be output in yaw, pitch, and roll coordinates, rather than in psi, theta, and phi coordinates. First Adams rotates about the z-axis, then about the new negative y-axis (y'), and then about the second new x-axis (x"). Note that Yaw Pitch Roll only affects rotational displacement output. Adams View always outputs angular velocities and accelerations as vectors, with orthogonal x, y, and z components. |