simulation single_run replay
Allows you to replay an animation of the last simulation.
This command has no parameters
Extended Definition:
1. Replaying an animation displays the results much faster than if you simulate the model again and watch the frames update as the solution calculates results. You can also replay an animation of a saved simulation.
How Adams View replays your simulation depends on whether or not you have finished the simulation and reset the model back to its initial design configuration.
■If you have run a simulation, or part of a simulation, but not set the model back to its initial configuration, when you select to replay the animation, Adams View animates the model up to the last simulation step and leaves your model there.
■If you reset your model back to its initial configuration, when you select to replay the animation, Adams View automatically sets the model back to the initial design configuration when the animation is complete.