Performing Adams Driveline Analyses
To create a Bench Test Assembly:
1. In the Standard Interface, from the File menu, point to New, and then select Subsystem.
2. Fill in the dialog box:
Subsystem Name: AWD_driveline
Minor Role: any
Template Name: mdids://private/templates.tbl/_AWD_driveline.tpl
3. Select OK.
4. Point to File → New →Bench Test Assembly.
5. Fill in the dialog box:
Assembly Name: AWD_driveline_tester
Right-click in the bottom Subsystems field and select: AWD_driveline
6. Select OK.
To submit a simulation:
1. Point to Simulate → Full-Vehicle Analysis → Driveline Tests → Step Torque
2. Fill in the dialog box:
Output Prefix: AWD_driveline
End Time: 2
Number Of Steps: 400
Mode of Simulation: interactive
Road Data File: mdids://acar_shared/roads.tbl/2d_flat.rdf
Gear Position: 1
Initial Torque Value: 0
Final Torque Value: 1e5
Step Start Time: 0.5
Duration of Step: 1
Engine Dyno: AWD_driveline.ues_driveline_input
3. Select OK.
The simulation will run and the results will be loaded. Switch to the PostProcessor and investigate the results.